Lawn Mower Operator's Manual

SECTION 1: FINDING YOUR MODEL NUMBER

This Operator’s Manual is an important part of your new walk behind. It will help you assemble, prepare and

maintain your walk behind. Please read and understand what it says.

Before you start to prepare your walk behind for its first use, please locate the model plate and copy the

information from it in this Operator’s Manual. The information on the model plate is very important if you need

help from your dealer or customer support department.

• Every walk behind has a model plate. You can locate it by standing behind the unit in the operating

position and looking down at the rear of the deck.

SECTION 2: UNPACKING INSTRUCTIONS

REMOVE UNIT FROM CARTON

• Remove staples, break glue on top flaps, or

cut tape at carton end and peel along top flap

to open carton.

• Remove loose parts if included with unit (i.e.,

owner’s manual, etc.).

• Cut along dotted lines and lay carton down

flat.

• Remove packing material.

Roll or slide unit out of carton. Check carton

thoroughly for loose parts.

DISCONNECT SPARK PLUG WIRE

Before setting up your lawn mower, disconnect the

spark plug wire from the spark plug, and ground it

against the engine by attaching rubber boot to a bolt

or metal clip to the grounding post on the engine.

See Figure 1

Figure 1

Spark Plug Wire

Spark Plug