Operator's Manual Leaf Blowers Model Series 650 IMPORTANT: READ SAFETY RULES AND INSTRUCTIONS CAREFULLY Warning: This unit is equipped with an internal combustion engine and should not be used on or near any unimproved forest covered, brush-covered or grass-covered land unless the engine's exhaust system is equipped with a spark gamester meeting applicable local or state laws (if any).
TABLE OF CONCH Content Page Content Page Important Safe Operation Practices 3 Maintaining Your Leaf Blower 7 Assembling Your Leaf Blower 5 Trouble Shooting 8 Operating Your Leaf Blower 8 Illustrated Paris List 9 Adjusting Your Leaf Blower 8 Warranty 12 FINDING MODEL NUMBER This Operator's Manual is an important part of your new leaf blower. 1t will help you assemble, prepare and maintain the unit for best performance. Please read and understand what it says.
SECTION 1: IMPORTANT SAFE OPERATION PRACTICES WARNING: This symbol points out important safety instructions which, if not followed, could endanger the personal safety and/or property of yourself and others. Read and follow all instructions in this manual before attempting to operate this machine. Failure to comply with these instructions may result in personal injury. When you see this symbol heed its warning.
Service 1 A Use extreme care in handling gasoline and other fuels. They are extremely flammable and the vapors are explosive. Tore fuel and oil in approved containers, away from heat and open flame, and out of the reach of children. Check and add fuel before starting the engine. Never remove gas cap of add fuel while the engine Is running. Allow engine to cool at least two minutes before refueling.
SECTION 2: ASSEMBLING YOUR LEAF BLOWER IMPORTANT: This unit is shipped without gasoline or ofl in the engine. Be certain to service engine with gasoline and oil as instructed in the separate engine manual before operating your unit. NOTE: Reference to right or left hand side of the leaf blower is observed from the operating position. Upper Handle Removing Unit From Carton curved Head + Remove staples, break glue on top flaps, or cut Bolt.
SECTION 3: OPERATING YOUR LEAF BLOWER WARNING: Read, understand, and follow A all instructions and warnings on the machine and in this manual before operating. Gas And 0il Fill-Up Service the engine with gasoline and oil as instructed in the separate engine manual packed with your leaf blower. Read instructions carefully. WARNING: Use extreme care when hand sling gasoline. Gasoline is extremely flammable and the vapors are explosive. Never fuel machine indoors or while the engine is hot or running.
SECTION 5: MAINTAINING YOUR LEAF BLOWER nuance or repairs, stop the engine, wait until the machine comes to a complete stop, disconnect the spark plug wire and ground against the engine to prevent unintended starting. Lubrication Wheels: Rear wheels are provided with light oil bearings. Lubricate by placing a few drops of SAE 30 oil on each bearing once a season. Engine: Follow the separate engine manual packed with you unit for lubrication instructions.
SECTION 6: TROUBLESHOOTING Problem Cause Remedy Engine fails to start 1. Spark plug wire disconnected. 1. Connect wire to spark plug. 2. Fuel tank empty or stale fuel. 2. Fill tank with clean, fresh gasoline. 3. Throttle control lever not in correct | 3. Mace throttle lever to start position. starting position. (if Equipped) 4. Blocked fuel line. 4. Clean fuel line. 5. Faulty spark plug. 5. Clean, adjust gap, or replace. 8. Engine flooded. 8. Wait a few minutes ta restart, but do not prime.
SECTION 7: PARTS LIST FOR MODEL SERIES 650 Ret Part No. Part Description Ref. Part No. Part Description 1. 145408 Engine Housing Bracket 16 710-1254 Hex Bolt x 1.25 2 710-0807 Hex Self Tapping Screw 5/16 x 5 71012731 Hex Bolt x 2.75 3 710-1260A Hex Screw 516-18 x 75 17 736-0217 Neck Washer 38 4. 736-0170 Special L-Washer 5/16” 681-0075A Blower Impeller Assembly 8 14541 Right Angle Bracket 681-040151 Blower Impeller Assembly 8. 710-0627 Hex Locking Bolt x .75 18.
Model Series 650 2720 110; 32 Ret. Part No. Part Description Ret Part No. Part Description 1. [740-0784 Upper Handle 23. | 736-0300 Flat Washer |726-0100 Push Nut 3/8 24. [750-0528 Spacer 382 .180Lg 3. 720-0171 Crank Knob 25. [736-0168 Lock Washer 3/8 ID 4. |736-0117 Flat Washer 385 [712-0354 Hex Nut 3/8-8 8. |710-0805 Hex Bolt 516-18 x 1.50 27. [710-0118 Hex Bolt 516-18 x 75 7. 16453 Engine Mounting Frame Assembly 28. [711-0797 Ferrule 8. |738-01189 Lock Washer 5/16 1D 28. [720-0241 Hand Knob 9.
MANUFACTURER'S LIMITED WARRANTY FOR: MTD) The limited warranty set forth below is given by MTD LLC with respect to new merchandise purchased and used in the United States, its possessions and territories. “MTD warrants this product against defects in material and workmanship for a period of two (2) years commencing on the date of original purchase and will, at its option, repair or replace, free of charge. any part found to be defective in materials or workmanship.
