Manual

ManualsBrandsMTD ManualsLog SplitterOfficial MTD log splitter

Operator's Manual

Log Splitter

Model Series

550 through 570

IMPORTANT: Read safety rules and instructions carefully before operating equipment.

Warning: This unit is equipped with an internal combustion engine and should nat be used an or near any unimproved forest-

covered, brush-covered or grass-covered land unless the engine's exhaust system is equipped with a spark arrester meeting

applicable local or state laws (if any). If a spark arrester is used, it should be maintained in effective working order by the operator.

In the State of California the above is required by law (Section 4442 of the California Public Resources Code), Other states may have

similar laws. Federal laws apply on federal lands, A spark arrester for the muffler is available through your nearest engine authorized

service dealer or contact the service department, P.O, Box 368022 Cleveland, Ohio 44136-9722,

MTD LLC, P.O. BOX 361131 CLEVELAND, OHIO 44136-0019

PRINTED IN U.S.A.

FORM NO. 770-10529B

(9/2002)

Summary of content (16 pages)

PAGE 1
Operator's Manual Log Splitter Model Series 550 through 570 IMPORTANT: Read safety rules and instructions carefully before operating equipment. Warning: This unit is equipped with an internal combustion engine and should nat be used an or near any unimproved forestcovered, brush-covered or grass-covered land unless the engine's exhaust system is equipped with a spark arrester meeting applicable local or state laws (if any).
PAGE 2
TABLEOFCONTENTS Content Page Important Safe Operation Practices ................................................................... 3 Assembling Your Log Splitter ............................................................................ 5 Know Your Log Splitter ...................................................................................... 7 Operating Your Log Splitter ............................................................................... 8 Adjusting Your Log Splitter ..........
PAGE 3
SECTION1: IMPORTANT SAFEOPERATION PRACTICES _b WARNING: This symbol points out important safety instructions which, if not followed, could endanger the personal safety and/or property of yourself and others. Read and follow all instructions in this manual before attempting to operate this machine. Failure to comply with these instructions may result in personal injury. When you see this symbol - heed its warning.
PAGE 4
equipment, movemachine toanother area.Wait5 minutes before starting theengine. i. Never storethemachine orfuelcontainer inside wherethereisanopenflame,sparkorpilotlight asonawaterheater, space heater, furnace, clothes dryerorothergasappliances. j. Allowmachine tocool5minutes before storing. Operation 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 17. Before starting this machine, review the "Safety Instructions".
PAGE 5
SECTION2: ASSEMBLING YOURLOGSPLITTER Attachingthe Tongue UnpackingfromCrate • • • • Pry top, sides, and ends off the crate. Set panels aside to avoid tire puncture or personal injury. Remove and discard plastic bag that covers unit. Remove any loose parts if included with unit (i.e., operator's manual, etc.) Cut and remove straps which secure parts to bottom of crate. Unbolt any remaining parts which may be bolted to the bottom of the crate. WARNING: Use extreme caution this machine.
PAGE 6
Disconnect the log cradle from the beam on the side of the control valve. See Figure 4. Preparingthe LogSplitter • • Lock Washer • Lubricate the beam area (where the splitting wedge will slide) with engine oil; do not use grease. Remove vented reservoir dipstick, which is located in front of the engine on top of the reservoir tank. See Figure 6. Fill the reservoir tank with Dexron III automatic transmission fluid or 10W AW hydraulic fluid. NOTE: The reservoir tank has a capacity of 3.5 gallons.
PAGE 7
SECTION3: KNOWYOURLOGSPLITTER Compare the illustration in Figure 7 below with the controls on your log splitter, and get familiar with its features before starting to operate. Know how to stop the machine quickly in the event of an emergency.
PAGE 8
SECTION4: OPERATING YOURLOGSPLITTER _b WARNING: Read, understand, and follow all • • Fill up gasoline if necessary. Lubricate with engine oil the beam area where splitting wedge will slide. Do not use grease to lubricate. Make sure to lubricate both the front and the back of the beam face. • Attach spark plug wire to the spark plug. instructions and warnings on the machine and in this manual before operating.
PAGE 9
HorizontalPosition • • Pull the vertical beam lock out and rotate it down. See Figure 7. Pivot beam to the horizontal position. The beam will lock automatically in horizontal position. Stand behind the reservoir tank to operate control handle and to stabilize the log. See Figure 8B. OperatingTips Always: 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. Use clean fluid and check fluid level regularly. Use Dexron III Automatic Transmission Fluid or 10W AW hydraulic fluid.
PAGE 10
SECTION5: ADJUSTINGYOURLOGSPLITTER any ,_ NOTE: The gibs may be rotated and/or tumed over for even wear. any WARNING: Do notfirst at stopping time make adjustments without engine, • disconnecting spark plug wire, and grounding it against the engine. • • WedgeAssemblyAdjustment As normal wear occurs and there is excessive "play" between the wedge and beam, adjust the bolts on the side of the wedge assembly to eliminate excess space between the wedge and the beam. See Figure 10.
PAGE 11
on the tank, hydraulic pump or valve. For this job, contact your nearest service dealer. • • HydraulicFilter • Change the hydraulic filter every 50 hours of operation. Use only a 10 micron hydraulic filter. Order part number 723-0405. • BeamandSplittingWedge • • Lubricate both sides of the beam (where it comes into contact with the splitting wedge), before each use, with engine oil.
PAGE 12
SECTION7: STORINGYOURLOGSPLITTER Prepare your log splitter for storage at the end of the season or if the log splitter will not be used for 30 days or more. 4_ • • WARNING: store machine with fuel in the fuel tank Never inside of building where fumes may reach an open flame or spark, or where ignition sources are present such as hot water and space heaters, furnaces, clothes dryers, stoves, electric motors, etc. • • • • • Clean the log splitter thoroughly.
PAGE 13
HydraulicTroubleshooting Problem Cylinder rod will not move Cause Remedy 1. Broken drive shaft. 1. 2. 2. 4. Shipping plugs left in hydraulic hoses. Set screws in coupling not adjusted properly. Loose shaft coupling. 5. 6. 7. 8. Gear sections damaged. Damaged relief valve. Hydraulic lines blocked. Incorrect oil level. 3. 9. Damaged directional valve. 10. Blocked directional valve. See authorized service dealer. Disconnect hydraulic hoses, remove shipping plugs, reconnect hoses. 3.
PAGE 14
SECTION9: PARTSLISTFORMODELSERIES550 THROUGH 570 2 1 29 28 _l Z 13 1_6 17 31 2 26 85 57 j60 21 40 53 C 65 A 69 45 84 70 74 68 75 67 j 42 78 48 81 79 _ 82 14 79
PAGE 15
ModelSeries550 through570 Ref. No. Part No. Ref. No. Part Description Part No. Part Description 1. 718-0769 710-3097 727-0634 Hydraulic Cylinder Hydraulic Tube 41. 2. 42. 712-0798 Carriage Bolt 3/8-16 x 1.0 Hex Nut 3/8-16 3. 710-1018 Hex Cap Screw 1/2-20 x 2.75 43. 781-0682 Leg Tray 4. 737-0192 781-0686 Leg Tray Bracket 5. 781-0526 90 Degree Solid Adapter Hose Guard 44. 45. 681-0161 Frame Assembly 6. 737-0153 Return Elbow 46. 726-0214 Push Cap 7.
PAGE 16
MANUFACTURER'S LIMITED WARRANTY The limited warranty set forth below is given by MTD LLC with respect to new merchandise purchased and used in the United States, its possessions and territories. MTD LLC warrants this product against defects for a period of two (2) years commencing on the date of original purchase and will, at its option, repair or replace, free of charge, any part found to be defective in materials or workmanship.