Specifications

Fuel System And Carburetor

Carburetor insulator

NOTE: A cracked spacer or a leaking gasket between the

spacer and the cylinder could result in a lean run or

prevent the impulses from the engine from driving

the fuel pump.

To remove/replace the carburetor insulator:

1. Remove the carburetor by following the procedures

described in the carburetor section of this chapter.

2. Remove the throttle cable by pressing in the tabs

located in the slots while lifting the cable out.

See Figure 5.29.

3. Remove the three screws that secure the engine

cover to the engine using a T-20 torx driver.

See Figure 5.30.

4. Slide the engine cover off of the rear of the engine.

5. Remove the carburetor insulator block using a T-25

torx driver. See Figure 5.31.

Figure 5.29

Press in

O-ring

the tabs

Figure 5.30

Screws

Figure 5.31

Insulator block

For Parts Call 606-678-9623 or 606-561-4983