Specifications

P25 Series of Engines

5. Remove the clutch rotor with a clutch removal tool.

NOTE: The P25 engines use a rubber clutch. Clutch

tool number 797-00070 can be used to

remove it. See Figure 7.8.

NOTE: The clutch is used to disconnect the drive

shaft for starting. It will engage at 2,000

RPM. This means the trimmer head will spin

at idle speed.

6. Install the clutch rotor.

NOTE: The big washer goes between the rotor and

the starter housing. See Figure 7.9.

NOTE: The small thrust washer goes on top of the

rotor.

‘

NOTE: The side of the rotor with the flange faces

the clutch drum. See Figure 7.10.

7. Torque the rotor to 210 - 230 in lbs (24 - 26 Nm).

8. Slide the clutch drum onto the crankshaft and

tighten it to a torque of 38-40 in. lbs.(4 - 5 Nm).

9. Install the clutch housing and the drive shaft assem-

bly following the steps mentioned earlier in reverse

order.

10. Test run the engine/trimmer before returning it to

service.

Figure 7.8

Part number

797-00070

Big washer

Figure 7.9

Flange

Figure 7.10

Flange

For Parts Call 606-678-9623 or 606-561-4983