Specifications

Engine Assembly

5. Rotate the flywheel so that the magnets are away

from the module.

6. Remove the two screws that secure the ignition mod-

ule to the block using a T-20 torx driver.

See Figure 8.4.

7. Remove the module.

8. Remove the flywheel by applying a sharp blow to the

crankshaft while gently prying upward with a pry bar.

The flywheel will loosen then lift it off. See Figure 8.5.

NOTE: If replacing a short block, exchange the crankcase

and cylinder with the short block and follow the

previous steps in reverse order.

9. Remove the muffler using a T-27 torx driver or a 5/

16” wrench. See Figure 8.6.

Figure 8.4

Screws

Figure 8.5

Never hit the

crank shaft with

a hammer!

use a brass punch

! CAUTION! CAUTION

Never strike the crankshaft

directly with a hammer. To pre-

vent damage to the crankshaft

use a brass punch or a piece of wood

between the hammer and the crankshaft.

Figure 8.6

Muffler screws

For Parts Call 606-678-9623 or 606-561-4983