Operator's Manual CRAFTSMAN 4-Cycle GAS TRIMMER Model No. 316.791961 INCREDIBILITY BELIEVABLE STARTING EASE e SAFETY * ASSEMBLY ¢ OPERATION = MAINTENANCE e PARTS LIST » LIFESPAN, P. 13 CAUTION: Before using this product, read this manual and follow all safety rules and operating instructions. Sears Brands Management Corporation, Hoffman Estates, IL 60179 U.S.A.
RULES FOR SAFE OPERATION CALIFORNIA PROPOSITION 65 WARNING Ete A THE ENGINE EXHAUST FROM THIS PRODUCT CONTAINS CHEMICALS KNOWN TO THE STATE OF CALIFORNIA TO CAUSE CANCER, BIRTH DEFECTS OR OTHER REPRODUCTIVE HARM. TABLE OF CONTENTS Safely Ides Warranty Know Your Unit Assembly Instructions . Off and Fuel Information Starting/Stopping Instructions Operating instructions Maintenance and Repair constructions Cleaning and Storage TOUR Antiphonal ACCEPTABLY ete 8 Troubleshooting Chart Lo...
RULES FOR SAFE OPERATION «Use the unit only In daylight or good artificial it «Avoid accidental starting. Be In the starting position whenever pulling the starter rape. The operator and Unit must be in a stable position while starting. See Starting/Stopping Instructions, Use the fight tool. Only use this tool for tha purpose intended Dar not overreach, Always keep proper footing and balance Ways hood the unit with both hands when operating. Keep a fir grip on bath the front and rear handle oF gps.
AiR ERR ess CRAFTSMAN 2 YEAR FULL WARRANTY FOR 2 YEARS from the date of purchase, this product is warranted against any defects In material or workmanship. Defective product wit receive free repair of free replacement If repair is unavailable. For warranty coverage details to obtain repair or replacement, visit the web site: www. craftsman.com This warranty covers ONLY defects in material and workmanship.
DRT ceE led (eh OIL'AND FUEL INFORMATION ADJUSTING THE D-HANDLE 1. Loosen the screws on the Handiness (Fig. 2). E 2. While holding the unit in the aerating position (Fig. 13). position the D-handier to the location that provides the best grip. 3. Tighten the clamp screws evenly, nth the D-handier is SECLUDE. Shaft Grip O-Handle Fig.
OIL AND FUEL INFORMATION The use of fuse additives, such as STA-BILE Gas Stabilizer or an equivalent, will Inhibit corrosion and minimize the formation of gum deposits. Using a fuel additive can keep fuel from forming harmful deposits in the carburetor for up to sit (6) months. Add fuel additive per gallon of fuel according to the instructions on the fuel additive container, NEVER add fuel additives directly to the unit's gas tank.
OPERATING INSTRUCTIONS TIPS FOR BEST TRIMMING RESULTS « Keep the trimmer attachment parallel to the ground. * Trim only when grass and weeds are dry. * The cutting head and shield are designed to slow the unit to cut in either direction, from right to left or left fo right.
MAINTENANCE AND REPAIR INSTRUCTIONS NOTE: Use the bottle and split saved from initial Lie to measure the correct amount of olf The top of the label on the builtin measures approximately 3.04 fl.oz, {©0 ml) (Fig. £3). Cheek the level, Ses Checking the Cif Level If the level is fow, add a small Fil Lina amount of oll and Toa recheck. Do not overfill (Fig. 22). 5. Replace the oil fill plug. —— AIR FILTER MAINTENANCE Fig.
MAINTENANCE AND REPAIR INSTRUCTIONS * Both rocker arms move freely, Exhaust Rocker Arm and both valves are closed Adjusting Nat Falser if these statements are not true. = Gauge repeat pies 6. 7. Sid the feels gauge bestrewn nos nine aN J the rocker arm and he valve 1g ¢i76-g 152 mr prelim spring. Measure the Eh clearance between the valve EIN stern and rocker arm (Fig. 33). have Stem Measure both the intake and Fig a loyalist valves, The recommended clearance for both intake and exhaust is L003 = 006 in.
TROUBLESHOOTING Primer bulb wasn't pressed enough Old fuel Fouled spark plug Cold weather start lever is in closed position PROBLEM ENGINE WILL NOT START Therapy fuel dank SOLUTION Fill fuel tank with fuel Press primer.
SPECIFICATIONS ae Engine Type Displacement . . Operating RPM . idle Speed RPM ignition Type, ignition Switch Co Valve clearance G06 in. o 076-0162 mm} Spark Plug Gap JP 0.025 inch (0.635 mr} SOAK PHIL. ooo Champion ADZE or equivalent chip Lubrication ee ee Loewe. CAESURA Crankcase Of Capacity . 3.04 07 {90 my Air-Coaled, 4-Cycle . 18cu.in. (28 uc) . 6,800+ rpm . 2.800 3,600 rpm . Electronic Rocker Switch 0.000 + Unleaded Carburetor . | Diaphragm, All Position Starter...
INSTRUCCIONES DE ARRANQUE ¥ APAGADO. INSTRUCCIONES DE MANTENIMIENTO Y REGIONARIO 7. Oprima of control del arreglador y efe gue el motor se caliente durante NOTA: Para ver fa lista completa de términos y (a cobertura da los 30 a 60 segundos. dispositivos de control ds emisiones como par achispas El motor no arana, regreso al paso 5. silenciador, carburador, etc. lea la declaración de Californiana El motor sa para mientras oprime ef regulador, regrese al paso 4. que viene junto oon la unidad.
INSTRUCCIONES DE MANTENIMIENTO Y REPARATIVO INSPECCIÓN DEL NIVEL DE ACEITE PRECAUCIÓN: Para evitar un desgaste excesivo del motor y of dacio de la Unidad, mantenga siempre ef nivel de afecte correcto en &f cárter del aliena. No opere nunca la unidad con of aceite debajo del extremo inferior de la varilla de medición. No podemos exagerar la importancia de verificar y mantener ef nivel correcto dle aceite en el cárter del encinal. Inspeccione el nivel de aceite antes de cada uso: 1.
PARTS LIST REPLACEMENT PARTS MODEL 316.791961 4-CYCLE GAS TRIMMER Part No.
27h est fag REPLACEMENT PARTS MODEL 316.791961 4-CYCLE GAS TRIMMER lem Part No.
Your Home For troubleshooting, product manuals and expert advice: E @ manageability www.managemylife.com For repair — in your home ~ of all major brand appliances, lawn and garden equipment, or heating and cooling systems, no matter who made it, no matter who sold it! For the replacement parts, accessories and owner's manuals that you need to do-it-yourself. Lo For Sears professional installation of home appliances | and items like garage door openers and water heaters.