Manual

Bracket
@
Vertical
Hex
Nuts
Lock
Washers
Tongue
Assembly
Horizontal
Hex
Bolts
Beam Lock
Figure 1
Remove the spring clip and clevis pin from the jack
stand. Pivot the jack stand to the operating position
and secure with spring clip and clevis pin.
See Figure 2.
Figure 3
PreparingTheLogSplitter
Lubricate the beam area where the splitting wedge
will slide with engine oil (DO NOT USE GREASE).
Remove reservoir vent plug. See Figure 4.
Clevis Pin -_= P
Tongue
E]_f[ Assembly S rin
_S_
Jack
Figure 2
Cut the two straps from around the reservoir tank
assembly.
Remove the lag screw and washer which secures
the beam assembly to the bottom of the crate.
Lower the beam assembly to its horizontal position.
Make certain the beam is locked securely with the
horizontal beam lock. See Figure 3.
Pull the log splitter off the pallet.
Reservoir
Figure 4
Fill the reservoir tank to the within 3" to 3 1/2" from
the top of fill tube with Dexron III automatic trans-
mission fluid or 10W AW hydraulic fluid.
See Figure 5.
Check fluid level using a scale and do not overfill.
Replace vent plug securely.
NOTE: The reservoir tank has a capacity of approxi-
mately 4 gallons.