Manual

StoppingTheEngine
Turn the ignition key to the left to the OFF position.
Remove the key to prevent accidental starting.
WARNING: If you strike a foreign object,
stop the engine, disconnect the spark plug
wire(s) and ground against the engine.
Thorougly inspect the machine for any
damage. Repair the damage before
restarting and operating.
NOTE: If any problems are encountered, refer to the
Trouble Shooting Guide.
OperatingTheLawnTractor
WARNING: Always look down and behind
before and while backing up to avoid a back-
over accident.
WARNING: Before leaving the operator's
position. Always disengage PTO, shift into
neutral, set parking brake, stop engine and
remove key to prevent unintended starting.
• Move throttle control to full throttle to prevent strain
on the engine and to operate the cutting blades.
• Place the shift lever in either the FORWARD or
REVERSE position.
• Release the parking brake by depressing the
clutch-brake pedal, pressing outward on the speed
control lever and moving to desired position. Use
first speed position when operating the lawn tractor
for the first time.
• Release clutch-brake pedal slowly to put unit into
motion.
• The lawn tractor is brought to a stop by depressing
the clutch-brake pedal.
NOTE: When operating the unit initially, there will be
little difference between the highest two speeds until
after the belts have seated themselves into the pulleys
during the break-in period.
Be sure that the lawn is clear of stones, sticks, wire, or
other objects which could damage lawn mower or
engine. For best results and to insure more even grass
distribution, de not mow when lawn is excessively wet.
_, WARNING: Before leaving the operator's
position for any reason, disengage the
blades, place the shift lever in neutral,
engage the parking brake, shut engine off
and remove the key.
When stopping the unit to empty a grass bag, etc.,
follow the instructions above. This procedure will also
eliminate "browning" the grass, which is caused by hot
exhaust gases from a running engine.
If unit stalls with speed control in high speed, or if unit
will not operate with speed control lever in a low speed
position, proceed as follows.
• Place shift lever in NEUTRAL.
• Restart engine.
• Place speed control lever in high speed position.
• Release clutch-brake pedal fully.
• Depress clutch-brake pedal.
• Place speed control lever in desired position.
• Place shift lever in either FORWARD or REVERSE,
and follow normal operating procedures.
OperatingTheCuttingBlades
The cutting blades may be engaged while the lawn
tractor is moving or standing still. DO NOT engage the
cutting blades abruptly as the sudden belt tension on
the pulley may cause the engine to stall.
WARNING: Keep feet and hands away
from the discharge opening, the blades or
any part of the deck. When the unit is used
for anything other than mowing operations,
the blade drive should be disengaged.
Move the lift lever into the BLADES STOP position to
raise the deck and disengage the blades.
GrassCollectorAvailable
Grass Collector Model OEM-190-063 is available as
optional equipment for lawn tractors with 38" and 42"
decks. Grass Collector Model OEM-190-103 is
available for lawn tractors with 46" decks.
WARNING: Do not operate the cutting
deck unless the discharge cover or entire
grass catcher are in the proper operating
position,
NOTE: Under normal usage bag material is subject to
wear, and should be checked periodically. Be sure to
use only factory authorized replacement bag.
14