Manual

12" Drain
Ho__ Drain
Valve
Figure 21
FuelFilter
Your unit is equipped with a replaceable in-line fuel
filter. Replace filter whenever contamination or
discoloration is noticed. Order replacement filter
through your authorized engine service dealer.
CleaningEngineAndDeck
Any fuel or oil spilled on the machine should be wiped
off promptly, Grass, leaves, and other dirt must not be
left to accumulate around the cooling fins of the engine
or on any part of the machine.
Clean the underside of the deck after each mowing.
We do not recommend the use of pressure washers or
garden hose to clean your unit. They may cause
damage to electric components, spindles, pulleys,
bearings or the engine. The use of water will result in
shortened life and reduce serviceability,
CuttingBlades
REMOVALFORREPLACEMENTORSHARPENING
A
WARNING: Be sure to disconnect and
ground the spark plug wire(s) and remove
ignition key before working on the cutting
blade to prevent accidental engine starting.
Protect hands by using heavy gloves or a rag
to grasp the cutting blades.
• Remove the hex flange nut which holds the blade to
the blade spindle.
• Remove the blade from the spindle.
Sharpening
Remove the cutting blades by following the directions
of the preceding section.
When sharpening the blades, follow the original angle
of grind as a guide, it is extremely important that each
cutting edge receives an equal amount of grinding to
prevent an unbalanced blade. An unbalanced blade
will cause excessive vibration when rotating at high
speeds, may cause damage to the mower and could
break, causing personal injury.
The blade can be tested for balance by balancing it on
a round shaft screwdriver, Remove metal from the
heavy side until it balances evenly.
Reassernbly
When replacing blades, be sure to install the blade
with the side of the blade marked "Bottom" (or with
part number) facing the ground when the mower is in
the operating position. Carefully align "star" on blade
with "star" on spindle. Secure with hex flange nut.
BladeMountingTorque
Hex Flange Nut: 840 in. lb. min., 1080 in, lb. max.
To ensure safe operation of your unit, all nuts and
bolts must be checked periodically for correct
tightness.
BatteryCareAndMaintenance
Batteries are sealed and are maintenance free.
ChargingTheBattery
The engine is equipped with an alternator which
charges battery when tractor is operated, Under normal
conditions, the battery only needs to be charged before,
during and after off-season storage. Fellow the
instructions under "Off-Season Storage."
2O