Specifications

Fuel System And Carburetor

Re-assembly of the carburetor

1. Place the carburetor in a clean area on the work

bench.

2. Inspect the throttle valve assembly for dirt and/or var-

nish.

3. Install the throttle valve assembly

4. If the needle valve seat is damaged, replace the car-

buretor. See Figure 5.25.

5. There are ports in the metering valve body. Inspect

them for dirt and/or varnish. See Figure 5.26.

NOTE: The carburetor used in this manual is a Walbro.

Depending on the application, the engine may

have a different carburetor. All carburetors have a

manufacturer name cast on them. It is advisable to

contact the carburetor manufacturer for the proper

rebuild procedure.

6. Inspect the primer pump body for dirt and/or varnish.

See Figure 5.27.

Figure 5.25

Needle valve

seat

Figure 5.26

The lines show the

paths of the different

ports

Filter screen

Figure 5.27

Primer pump body

Primer bulb

For Parts Call 606-678-9623 or 606-561-4983