Electric Lawn Mower Operator's Manual

Also, be certain the smaller front wheels and the larger

rear wheels are mounted correctly to the front and rear

of the mower as shown in Figure 1.

Figure 1

Assembling Handle

Installing the Lower Handles (Hardware A)

• Insert long end of the lower handle into the handle

base. Make certain the small hole in the end of the

handle is lined up with the hole in handle base.

• Using one of the two longer self tapping screws

from the hardware pack, insert the screw through

the tooth washer, flat washer, and the handle cap

as shown in Figure 2.

• Align the handle cap so it rests flush against the

handle base, and tighten the screw into the lower

handle using a phillips screwdriver.

• Repeat this step for the remaining lower handle.

• Once both lower handles are installed, insert the

lower handle plugs into the upper ends of the lower

handles as shown in Figure 2.

Figure 2

Installing the Upper Handle (Hardware B)

• Standing behind the lawnmower with the upper

handle, make certain the two holes that will hold the

blade / motor control are on the right hand side.

See Figure 3 for proper alignment of upper handle.

Figure 3

• Align the holes in the lower handle with those of the

upper handle and insert the hex and handle bolts

through both holes as shown in Figure 3 .

Right Front View

Cutting Height Positions

Low

Medium

High

Front Wheel

Rear Wheel

Hubcap Assembly

Flat Washer

Tooth

Self Tapping

Handle Cap

Handle Base

Screw

Lower Handle

Plug

Washer