Instructions / Assembly

15se c t i O n 4 — as s e M b l y & in s t a l l a t i O n
With the bagger cover open, install the upper chute over 15.
the chute adapter, and rest the top so that the chute
support sits in the upper chute groove. See Fig. 4-27.
Note: Make sure to align the upper chute with the ridges
on the bagger support bracket.
opening so that the entire deck opening is covered by the
chute elbow. See Fig. 4-23.
Secure the chute elbow to the tractor’s deck by hooking 12.
the chute strap onto the ball pin installed earlier on the
deck. See Fig. 4-24.
Install the chute adapter onto the chute elbow by lining up 13.
the tabs and sliding the adapter over the chute elbow, as
in Fig. 4-25. Secure the chute adapter by installing the two
ratchet clips included in the hardware pack in the holes
provided.
Peel the backing off of the self-adhesive foam strip (721-04388) 14.
that has been included with your grass collector. Apply it to
the upper chute, flush against the flange as shown in Fig. 26.
Figure 4-23
Figure 4-25
Figure 4-27
Figure 4-26
Figure 4-24
Flange