- mtd chipper shreder vacuum operator's manual model series 020

6
Figure 3-1
IMPORTANT: This unit is shipped without gasoline or oil
in the engine. Be certain to service engine with gasoline
and oil as instructed in the separate engine manual
before operating your machine.
NOTE: All references in this manual to the left or right
side of the chipper shredder vacuum is from the operat-
ing position only. Exceptions, if any, will be specified.
OPENING CARTON
Cut each corner of the carton vertically from top to
bottom.
Remove all loose parts.
Remove loose packing material.
1.
2.
3.
REMOVING UNIT FROM CARTON
Lift unit from the rear to detach it from underlying
carton material and roll unit out of carton.
Check carton thoroughly for any other loose parts.
NOTE: Make sure not to crimp cables while removing
loose parts or the entire unit from the carton.
LOOSE PARTS IN CARTON
(See Figure 3-1)
Upper and Lower Handle
Bag
Blower Chute (Optional)
Safety Glasses
Engine Oil (May be located in bag)
Operator’s Manual
1.
2.
•
•
•
•
•
•
3
Setting
Up Your
Chipper
Shredder
Vacuum
NOTE: All references
in this manual to the
left or right side of
the chipper shredder
vacuum is from the
operating position only.
Exceptions, if any, will
be specified.
IMPORTANT
This unit is shipped
without gasoline or
oil in the engine. Be
certain to service
engine with gasoline
and oil as instructed
in the separate engine
manual before operat-
ing your machine.
Bottle of Engine Oil
† If Equipped
Operator’s Manual
Safety Glasses
Lower Handle
Wing Nuts
Bag
†Blower Chute
Carriage
Bolts
Carriage
Screws
Handle Knobs
Upper Handle
Rope Guide
Wing Nut