Operator`s manual

10 Section 3 — ASSembly & Set-Up

3. Follow the steps below to complete handle assembly:

a. Pull upward on the handle 8 inches until holes in

lower handle (shown in Fig. 3-3 deck cutaway) line

up with holes in handle bracket. See Fig. 3-4.

NOTE: When pulling upward on handle, make sure to not

pull handle all the way out.

b. Insert the T-bolts removed earlier through the

handle brackets and lower handle and tighten

securely to secure the handle in place. See Fig. 3-4.

b. While stabilizing mower so it doesn’t move, pivot

upper handle up as shown in Fig. 3-2. Do not crimp

cable while lifting the handle up.

c. Reattach bolts and wing nuts removed earlier into

lower holes of handle as shown in Fig. 3-2 inset.

2. Remove the T-bolts from the handle brackets as shown in

Fig. 3-3.

Figure 3-3

Figure 3-4

Figure 3-2