Care and Cleaning Guide

25
CLEANING INSTRUCTIONS FOR WHIRLPOOL SYSTEMS
NOT EQUIPPED WITH THE OPTIONAL FILL-FLUSH OR
SIMPLE TOUCH CLEANING SYSTEMS
THE WHIRLPOOL SYSTEM SHOULD BE CLEANED PERIODICALLY. MTI BATHS
RECOMMENDS CLEANING AT LEAST ONCE A MONTH, NOT TO EXCEED 90 DAYS
BETWEEN CLEANINGS. ALWAYS USE CAUTION WHEN USING CHLORINE-BASED
PRODUCTS IN CONJUNCTION WITH OTHER CLEANING PRODUCTS. THE POSSIBILITY
OF HARMFUL FUMES COULD RESULT. ALWAYS RINSE THOROUGHLY.
Fill tub with warm water 2" above the highest jet and add one of the following to the bath water: 1/4 cup
of MTI’s Fresh Wave Cleaning Solution, 1 cup vinegar, or several drops of a low sudsing detergent mixed
with 1 cup warm water then followed with 1 cup of cool, clean water. Turn the system on for ve minutes
then let stand for an additional 15 minutes. Drain the tub and rell with cold water. Restart the system
for 10 minutes, then drain. If standard cleaning does not remove stubborn build-up or tough stains, your
jets can be easily removed with pliers for more thorough cleaning. Soak jets overnight in a pan lled with
warm water and mild dish soap, and scrub lightly with a soft bristled brush or place on top rack in dish-
washer, being careful to remove before drying cycle starts. Whirlpools with the optional Fill-Flush System or
Simple Touch System should refer to page 22 and 23 of this booklet for operating and cleaning instructions.
CLEANING INSTRUCTIONS FOR THE ACRYLIC SHELL
The cross-linked cast acrylic surface of all MTI acrylic products is among the glossiest, highest quality surfac-
es available. Its hard, non-porous surface prevents dirt from accumulating and resists stains better than other
materials. With normal use, cast acrylic will retain its beauty with only a minimal amount of care. To maintain
the high gloss, elegant look of the cast acrylic surface, follow these simple steps:
Use common household, non-abrasive cleaners for most cleaning jobs (for example: a mild dishwashing
detergent such as Ivory Liquid). Follow manufacturer’s directions and precautions. Do not use unless
the product label specifically states that it is safe for acrylic. Rinse well and dry with a soft, clean
cloth. Be sure to check the product label. Some products, although not containing abrasives, WILL dam-
age the acrylic over time.
Never use any type of “scrubbing bubbles” or aerosol spray cleaners on your
acrylic product unless it specifically states that it is safe for use on acrylic!
Never use abrasive cleansers. If any product feels gritty when rubbed between your fingers, do not use
on the acrylic surface or controls as permanent damage will occur.
Do not allow your cast acrylic surface to come into contact with nail polish, nail polish remover, Winter-
green oil, dry cleaning solution, lacquer thinners, gasoline, pine oil, etc.
Remove dust and dry dirt with a soft, damp cloth.
Clean grease, oil, paint or ink stains with isopropyl (rubbing) alcohol. Dry with a clean, soft cloth.
Avoid using razor blades or other sharp objects that might scratch the surface. Small scratches can be
removed by applying a thin coat of automotive polishing liquid and buffing lightly with a clean cloth. For
deeper scratches, sand the surface lightly with a 400 grit “wet or dry” paper and buff with a fine grit buffing
compound.
MTI strongly recommends a professional acrylic repair person for deep scratches or chips.