Installation Guide

15
# 5 ULTRA THERAPY WHIRLPOOL
WITH 12 OR MORE MICRO-JETS
AND TSUBO MASSAGE
FUNCTIONS
ON/OFF PUMP FOR POINT MASSAGE JETS
1st Press: The pump starts. LED light on.
2nd Press: The pump stops. LED light off.
ON/OFF PUMP FOR MICRO-JETS / TSUBO MASSAGE
IMPORTANT! YOU MUST TURN THE VOLUME CONTROL FOR THE MICRO-JETS DOWN UNTIL YOU
ARE SITTING IN FRONT OF THEM. IF ACTIVATED BEFORE, WATER MAY SPLASH OUTSIDE THE BATH.
1st Press: The Tsubo pump starts. LED light on.
2nd Press: The Tsubo pump stops. LED light off.
Press & hold 3 seconds: The Tsubo sequential pulse mode starts. LED will flash. The sequential pulse
mode automatically advances the system through the seven operational Tsubo modes every 10 seconds.
TSUBO MODE/SPEED CONTROL
Tsubo: Press to change the Tsubo pump (micro-jets) through the seven different operational modes.
Not available when the Tsubo is in sequential pulse mode.
AUTOMATICALLY STOPS AFTER 20 MINUTES
NOTE: This system is equipped with a Tsubo lock-out protection mode.
See p. 19 for more information.
# 2 ULTRA-THERAPY WHIRLPOOL
WITH 6 OR LESS MICRO-JETS
Includes keypad and pneumatic on/off
pushbutton for micro-jets.
FUNCTIONS
Whirlpool Jets
PUMP ON
1st Press: The pump starts. Use the air volume control to adjust
PUMP OFF
1st Press: The pump stops.
Micro-Jets
Press the pneumatic control to turn the micro jets on and off. The diverter will control the pressure of the
micro jets. Turn clockwise for greater pressure or counter-clockwise to decrease the force.