Installation Guide

# 6 STANDARD WHIRLPOOL /

AIR SYSTEM COMBINATION WITH

LED LIGHTING

FUNCTIONS

ON/OFF FOR AIR SYSTEM

1st Press: The blower turns on at 30% power. Use the up and down arrows to increase or decrease

the speed. Please note: 20% is the minimum. If the lights for the up & down arrows go off, they can

be reactivated by gently pressing the on/off button

2nd Press: The blower turns off.

PULSATION MODE

1st Press: Standard wave. Speed will vary gradually from minimum to maximum.

2nd Press: Standard pulse. Speed will go quickly, alternating from minimum to maximum.

3rd Press: Blower returns to maximum speed.

4th Press: Returns to pulsation mode.

PUMP ON/OFF

1st Press: The pump turns on.

2nd Press: The pump turns off.

ON/OFF FOR LED LIGHTS

1st Press: Turns lights on to basic color mode, starting with white. Use the up and down arrows to

move light through the basic colors.

2nd Press: Slow rainbow cycle - Use up and down arrows to increase or decrease the speed of the cycle.

3rd Press: Slow aqua-blue-green cycle. Use the up and down arrows to increase or decrease the

speed of the cylcle.

Press and hold light button at any time to turn light off.

SPA MODES

1st Press: Turns the Spa Mode on. There are three different pre-set Spa Modes. Energetic, Relaxing and

Deep Tissue. Use the up and down arrows to choose from the different selections. Each Spa Mode will

operate the tub functions automatically for 20 minutes. Simply sit back and enjoy!

2nd Press or press and hold for one second: Spa Mode off.

AUTOMATICALLY STOPS AFTER 20 MINUTES

NOTE: The air blower will turn on by itself approximately 7 minutes after tub is completely drained.

See p. 19 for more information.

OR STREAM BATH WITH AIR SYSTEM &

LED LIGHTING