Installation Guide

17
# 8 ULTRA THERAPY WHIRLPOOL /
AIR SYSTEM COMBINATION
FUNCTIONS
ON/OFF PUMP FOR POINT-MASSAGE JETS
1st Press: The pump starts. LED light on.
2nd Press: The pump stops. LED light off.
ON/OFF PUMP FOR MICRO-JETS / TSUBO MASSAGE
IMPORTANT! YOU MUST TURN THE VOLUME CONTROL FOR THE MICRO-JETS DOWN UNTIL YOU
ARE SITTING IN FRONT OF THEM. IF ACTIVATED BEFORE, WATER MAY SPLASH OUTSIDE THE BATH.
1st Press: The Tsubo pump starts. LED light on.
Press & hold 1 second: The Tsubo pump stops. LED light off.
Press & hold 3 seconds: The Tsubo sequential pulse mode starts. LED will flash. The sequential
pulse mode automatically advances the system through the seven operational Tsubo modes every
10 seconds.
TSUBO MODE/SPEED CONTROL
Tsubo: Press to change the Tsubo pump (micro-jets) through the seven different operational modes.
Not available when the Tsubo is in sequential pulse mode.
Blower: Press & hold up or down arrow to increase or decrease the blower speed. Release pres-
sure at the desired speed.
Note: The up and down arrows will operate the last function button activated. (Tsubo pump or blower.)
ON/OFF - BLOWER
1st Press: The blower starts. LED light on.
Press & Hold 1 second - The blower stops. LED light off.
Press & Hold 3 seconds - Wave - Speed will vary gradually from maximum to minimum. Light will
flash quickly.
Press & Hold for 6 seconds - Pulse - Speed will go directly to minimum and then straight back to
maximum. Light will flash slowly.
SEQUENTIAL PULSE MODE - FOR MICRO-JETS
The sequential pulse mode automatically advances the system through the seven different Tsubo modes
every 10 seconds, when selected. To select this mode activate the micro jets; press and hold the Tsubo
Mode button / up arrow for 3 seconds. To cancel, press button up or down arrow on the keypad.
AUTOMATICALLY STOPS AFTER 20 MINUTES
NOTE: This system is equipped with a Tsubo lock-out protection mode for the micro-jets.
See p. 19 for more information.
OR STREAM BATH WITH AIR SYSTEM &
LED LIGHTING