Installation Sheet

Table Of Contents

Installation and Operational Manual

Designer Collection

Freestanding Tubs

9 / mtibaths.com

1. Select a location for the air blower and system components that meets the conditions noted on the

previous page.

2. Connect the air hose, keypad cable, and drain sensor wires that exit the bottom of the bath near the

drain to the blower. See photo "A" below.

Installation Instructions — Airbath

3. If your air system includes LED lights, and/or Radiance®, the control boxes will be placed next to the

blower and plug into the side of the blower. Connect the wires for the lights and heating pads for

Radiance® from the tub to leads that extend from the designated control box. See photo "B" below.

4. Do not crush or kink any of the connections.

5. Extensions: Do not attempt to disconnect any cables extending from the tub. Extensions are available

through MTI’s Technical Service Department. See page 8 for more details.

1  Air blower (remote mounted)

2 - Blower hose

3 - Keypad (installed on tub)

4 - Ethernet (keypad) cable

5 - Drain sensor wire

6 - Drain sensors - installed on tub

7 - LED lights - installed on tub

8 - Control box (remote mounted)