Installation Sheet

Do not operate this unit without guard over the suction fitting.
The water in a hydrotherapy bath should never exceed 40˚ C (104˚ F). Water temperatures
between 38˚ C (100˚ F) and 40˚ C (104˚ F) are considered safe for a healthy adult. Use
time should be limited to approximately 10 minutes, followed by a shower to cool down.
Longer exposures may result in hyperthermia, which can be fatal. The symptoms of this
condition are nausea, dizziness and fainting. Lower water temperatures are recommended
for extended use (exceeding 10 - 15 minutes) and for young children.
Since excessive water temperatures have a high potential for causing fetal damage during
the early months of pregnancy, pregnant or possibly pregnant women should limit hydro-
therapy bath water temperatures to 38˚ C (100˚ F).
The use of drugs or alcoholic beverages before or during hydrotherapy bath use may lead
to unconsciousness with the possibility of drowning. Never use the hydrotherapy bath while
under the influence of alcohol, anticoagulants, stimulants, antihistamines, vasoconstrictors,
vasodilators, hypnotics, narcotics or tranquilizers.
Persons with a medical history of heart disease, low or high blood pressure, circulatory
system problems, or diabetes should consult a physician before using a hydrotherapy bath.
Persons using medication should consult a physician before using a hydrotherapy bath
since medication may induce drowsiness while other medications may affect heart rate,
blood pressure and circulation.
DANGER: To reduce the risk of injury, enter and exit the bath slowly.
WARNING: Never operate electrically connected devices in or within 5' of the bath. Never
drop or insert any object into any opening within the hydrotherapy bath.
DANGER: Risk of electric shock. Connect only to circuits protected by a Ground Fault
Circuit Interrupter (GFCI). Such a device should be installed by a licensed electrician and
should be tested on a regular basis (at least monthly). To test the GFCI push the TEST but-
ton. The GFCl should interrupt the power. Push the RESET button and the power should
be restored. If the GFCI fails to operate in this manner there is the possibility of an electric
shock. DO NOT USE. Disconnect the unit and have the problem corrected by a qualified
service technician. To avoid the possibility of personal injury and discoloration of the acrylic
surface, the inlet water temperature should not exceed 60˚ C (140˚ F).
DANGER: Disconnect power before servicing.
A pressure wire connector is provided on the exterior of the pump or control within this unit
to permit connection of a bonding conductor between this unit and all other exposed metal
in the vicinity, as needed to comply with local requirements.
INSTALLER/OWNER BEARS ALL RESPONSIBILITY TO COMPLY WITH ALL
STATE AND LOCAL CODES WHEN INSTALLING THIS PRODUCT.
IMPORTANT! WHEN REQUIRED BY LOCAL CODES, INSTALL A RPZ (REDUCED
PRESSURE ZONE) BACKFLOW PREVENTION DEVICE TO EACH FAUCET SUPPLY LINE.
CAUTION: Do not use harsh abrasives or solvents for cleaning this unit.
SAVE THESE INSTRUCTIONS
▲
!
▲
!
▲
!
▲
!
▲
!
▲
!
▲
!
▲
!
▲
!
▲
!
▲
!
▲
!