Manualshelf

Installation Sheet

ManualsBrandsMTI Baths ManualsPlumbingAndrea 16 72" Drop In DoloMatte Air Tub Elite with Center Drain
21222324252627282930
24
SIMPLE TOUCH SYSTEM OPERATING INSTRUCTIONS
1. After bathing, drain the bath as usual, leaving the drain open.
2. Close all point-massage and rotary jets.
3. Remove detergent dispenser cap.
4. Add one of the following into the detergent dispenser: 2 oz. of MTI Fresh Wave Cleaner, 1 cup of
vinegar or a few drops of a low-sudsing liquid detergent mixed with 1 cup of warm water. For each
method, follow with 1 cup of cool, clean water.
5. Replace the detergent dispenser cap.
6. Depress the on/off button, which activates the Simple Touch Cleaning System.
7. The Simple Touch Cleaning System will run for three minutes, circulating water and detergent through the
air line, water line, and pump. Residue will then be flushed out the suction and down the drain. The clean-
ing process will automatically shut off, leaving your whirlpool bath plumbing system sparkling clean.
8. After the system shuts off, open the jets.
BASIC CLEANING INSTRUCTIONS FOR SINGLE PUMP SYSTEMS WITH FULL-SIZE JETS
AND MICRO-JET COMBINATIONS USING THE SIMPLE TOUCH SYSTEM.
1. Close all full-size jets by pushing in nozzle or turning face plate (depending on jet design).
2. Close all deck-mounted or wall-mounted micro-jet control valves.
3. Remove detergent dispenser cap.
4. Add one of the following into the detergent dispenser: 2 oz. of MTI Fresh Wave Cleaner, 1 cup of
vinegar or a few drops of a low-sudsing liquid detergent mixed with 1 cup of warm water. For each
method, follow with 1 cup of cool, clean water.
5. Replace the detergent dispenser cap.
6. Push Simple Touch button to activate. Water mixes with cleaning solution and flows from air line
to water line, through pump, out the suction and down the drain.
7. The system will run for approximately three minutes.
8. Open all deck-mounted or wall-mounted micro-jet control valves.
9. Again, push Simple Touch button to activate. Allow water to flow for approximately two minutes.
10. Open all full-size jets and allow water to run for the remainder of the Simple Touch
three minute cycle.