Specification Sheet
MTI BASICS® Tubs
GENERAL SPECIFICATIONS:
NOTE: Filling this tub to the maximum may require
an above average size or dedicated water heater.
IMPORTANT ORDERING & INSTALLATION INFORMATION:
Eective 081419 ©2019 by MTI Baths, Inc. Modification Rights Reserved.
CSA # MTIS-RFSX6636A
66"
33"
6½"
4½"
at surface for
mounting faucets
12"
35¾"
26"
22"
3"
17"
13½"
51"
59½"
110°
22½"
Installation: Freestanding
Material: Acrylic
Soaker Weight: 120 lbs / 54 kg
Maximum Fill: 73 gal to overflow
66" x 35.75" x 22.5"
MBRFSX6636A
Features a 4.5” wide flat deck surface on the drain side for mounting faucetry.
˚
Before ordering or installing, please consider future access to all equipment.
˚
Please measure tub on-site before building tub decking.
˚
Add bedding compound to fully level and support bottom of tub.
˚
The drain and overflow assembly is concealed between the walls of the tub, eliminating the need for an exposed drain kit.
˚
Tub includes an access panel (standard), for drain or Virtual Spout installation. Access panel can be eliminated by request,
which will increase installation diculty. Must specify on order.
˚
The Virtual Spout is installed below the water level of the tub. MTI supplies a Wilkins dual check valve and an Acme
in-wall atmospheric vent to prevent backflow into the potable water supply. However, some areas of the country require
additional backflow prevention when water is introduced to the bath below the water level. Please check local codes.
˚
Options listed cannot be combined with Designer Collection options.
˚
Specifications and configurations are subject to change without notice.
˚
Measurements are +1/2" and are subject to change without notice.
˚
Measurements herein supersede all others published prior to publication date shown below.