Specifications

MTI BASICS® Tubs
GENERAL SPECIFICATIONS:
NOTE: Filling this tub to the maximum may require an
above average size or dedicated water heater.
IMPORTANT ORDERING & INSTALLATION INFORMATION:
•
Freestanding tub is designed to install on a finished floor that is flat and level.
•
Tub has room between tub walls on the drain side and underneath for plumbing connections roughed-in
above the finished floor.
•
Tub has no access panel, however a panel may be specified at the time of order. Factory installed
access panel will be visibly located behind the waste and overflow. Please consider access panel
visibility before ordering and when planning final installation position.
•
The Virtual Spout is installed below the water level of the tub. MTI supplies a Wilkins dual check valve
and an Acme in-wall atmospheric vent to backsiphonage. However, some areas of the country require
additional backflow prevention when water is introduced to the bath below the water level. Please
check local codes.
•
Options listed cannot be combined with Designer Collection options.
CSA # MTIS-
1 of 2
©2021 by MTI Baths, Inc. Modification Rights Reserved
Effective 03 16 2021
• Before discarding tub crate, check for accessories that may be packaged inside.
• All product measurements are +1/2”.
• Specifications and configurations are subject to change without notice.
• Measurements herein supersede all others published prior to publication date below.
21¾"
44"
14"
16"
118°
60"
36"
66"
33"
7.5"
30"
27"
3"
Installation: Freestanding
Material: Acrylic
Soaker Weight: 125 lbs / 57 kg
Maximum Fill: 60 gal to overflow
66" x 36" x 21.75"
MBOFS6636A
OFS6636A