Owners Manual / Installation Guide

Use this unit only for its intended use as described in this manual. Do not use attachments
not recommended by the manufacturer. Never drop or insert any object into any opening.
Do not operate this unit without guard over the suction fitting.
The water in a whirlpool should never exceed 40˚ C (104˚ F). Water temperatures between
38˚ C (100˚ F) and 40˚ C (104˚ F) are considered safe for a healthy adult. Use time should
be limited to approximately 10 minutes, followed by a shower to cool down. Longer expo-
sures may result in hyperthermia, which can be fatal. The symptoms of this condition are
nausea, dizziness and fainting. Lower water temperatures are recommended for extended
use (exceeding10 - 15 minutes) and for young children.
Since excessive water temperatures have a high potential for causing fetal damage during
the early months of pregnancy, pregnant or possibly pregnant women should limit water
temperatures to 38˚ C (100˚ F).
The use of drugs or alcoholic beverages before or during whirlpool use may lead to
unconsciousness with the possibility of drowning. Never use the whirlpool while under the
influence of alcohol, anticoagulants, stimulants, antihistamines, vasoconstrictors, vasodila-
tors, hypnotics, narcotics or tranquilizers.
Persons with a medical history of heart disease, low or high blood pressure, circulatory
system problems, or diabetes should consult a physician before using a whirlpool.
Persons using medication should consult a physician before using a whirlpool since medica-
tion may induce drowsiness while other medication may affect heart rate, blood pressure
and circulation.
DANGER: To reduce the risk of injury, enter and exit the bath slowly.
WARNING: Never operate electrically connected devices in or within 5' of the bath. Never
drop or insert any object into any opening within the whirlpool.
DANGER: Risk of electric shock. Connect only to circuits protected by a Ground Fault
Circuit Interrupter (GFCI). Such a device should be installed by a licensed electrician and
should be tested on a regular basis (at least monthly). To test the GFCI push the TEST
button. The GFCl should interrupt the power. Push the RESET button and the power
should be restored.lf the GFC| fails to operate in this manner there is the possibility of an
electric shock. DO NOT USE. Disconnect the unit and have the problem corrected by a
qualified service technician.To avoid the possibility of personal injury and discoloration of
the acrylic surface, the inlet water temperature should not exceed 60˚ C (140˚ F).
DANGER: Disconnect power before servicing.
A pressure wire connector is provided on the exterior of the pump or control within this unit
to permit connection of a bonding conductor between this unit and all other exposed metal
in the vicinity, as needed to comply with local requirements.
INSTALLER/OWNER BEARS ALL RESPONSIBILITY TO COMPLY WITH ALL
STATE AND LOCAL CODES WHEN INSTALLING THIS PRODUCT.
CAUTION: Do not use harsh abrasives or solvents for cleaning this unit.
SAVE THESE INSTRUCTIONS
▲
!
▲
!
▲
!
▲
!
▲
!
▲
!
▲
!
▲
!
▲
!
▲
!
▲
!
▲
!
▲
!