Owners Manual / Installation Guide

3
SHOWER ENCLOSURE
INSTALLATION INSTRUCTIONS
Installation for each type of enclosure may vary. Please see the instructions included with your en-
closure. If you need additional information, please contact our Service Department at 800-783-8827.
CARE AND CLEANING FOR SHOWER ENCLOSURES
• Never use scouring powder pads or sharp instruments on metal pieces or glass panels.
• An occasional wiping down with a mild soap diluted in water is all that is needed to
keep the panels and aluminum parts looking new.
• We recommend wiping the glass panels with a squeegee after each use.
RADIANCE
®
INSTALLATION AND OPERATION
Each Radiance system comes with an on/off keypad and transformer box equipped with a
27” power cord. There are two heated zones for each Radiance system purchased. To install,
simply plug the transformer box into a 110 V, GFCI protected outlet and install the keypad using
the instructions below. The transformer box draws 5 amps. The control box must be accessible
for future service. The box is attached to cables leading to the Radiance heating grids that are
standard at 3-1/2’. A 9’ extension is available upon request.
Radiance Keypad Installation:
The radiance keypad ships loose (uninstalled) for all shower bases except MTI seated shower
bases. The keypad is intended to be installed either in the shower wall, or on an adjacent wall.
The keypad cable provided is 7 ½’ long, which will accommodate installation in the shower
wall. If the keypad is to be mounted further away, for example, in a nearby linen closet, an 8’
extension is available upon request. The keypad requires a 1-½” hole. The keypad has a sticky
backing, however, MTI recommends using some clear silicone for secure adhesion and water
resistance, particularly if installed within the shower walls.
The Radiance control box must be installed to allow future access for service. The box is
attached to cables leading to the Radiance heating grids that are standard at 3-1/2”, but a 9’
extension is available upon request.
Radiance Operation:
• To turn the system on, press the on/off button -
the keypad light will be on.
• Radiance is designed to be left on continually as
the initial heating can take up to an hour. The system
uses less energy than a standard light bulb.
• To turn the system off, press the on/off button once.
Radiance Keypad