Installation Sheet

9
OPTIONAL EQUIPMENT OPERATING INSTRUCTIONS (continued)
CHROMATHRAPY - KEYPAD FUNCTIONS
ON/OFF BUTTON:
1st Press: White light. LED light on (White is only available when
the system is initially turned on).
2nd Press: Light off. LED light off.
Press the on/off button - Light must be on for any mode to function.
MODE BUTTON FUNCTIONS:
1st Press: Aqua-Blue-Green Cycle. - First cycle 1.5 seconds between color
changes; then slows to 6 seconds between color changes.
2nd Press: Rainbow Cycle - Colors change from Aqua-Blue-Magenta-Red-Orange-Yellow-Green. First
cycle 1.5 seconds between color changes; then slows to 6 seconds between color changes.
3rd Press: Pressing the Mode button a third time will stop the system on the color displayed.To
change the color, use the up & down buttons to go through each color change in small increments.
(Alternatively, you could turn the light off and start over.)
UP ARROW FUNCTIONS:
To Change the Light Color - Pressing the up arrow will allow the lights to change through the basic
colors: Aqua, Blue, Magenta, Red, Orange, Yellow and Green.
When in the Rainbow Cycle - Press & hold to increase the cycle speed. Release pressure at the desired speed.
When in the Aqua-Blue-Green Cycle - Press & hold to increase the cycle speed. Release
pressure at the desired speed.
DOWN ARROW FUNCTIONS:
To Change the Light Color - Pressing the up arrow will allow the lights to change through the basic
colors: Aqua, Blue, Magenta, Red, Orange, Yellow and Green.
When in the Rainbow Cycle - Press & hold to decrease the cycle speed. Release pressure at the desired speed.
When in the Aqua-Blue-Green Cycle - Press & hold to decrease the cycle speed. Release
pressure at the desired speed.
STREAM BATH
Prior to installation, this bath must be water tested in accordance with the procedures outlined on page 2.
The tub will then be installed following the instructions starting on page 3.
To operate the unit, fill the tub to approximately 2” above the highest vent. Activate the on/off control on
the keypad. The flow, and force, of the stream of water may be adjusted by turning the vents. Pointing
them upward will result in a more vigorous “babbling brook” action, while pointing them downward will
slow the action of the Streambath.
STREAM BATH - KEYPAD FUNCTIONS
FUNCTIONS
PUMP ON
1st Press: The pump starts. Use the air volume control to adjust.
PUMP OFF
1st Press: The pump stops.