Installation Sheet

AIR BATH KEYPAD AND REMOTE CONTROL OPERATING INSTRUCTIONS

Please Note: Numbered instructions depict buttons in photo as seen from left to right on keypad or from top

to bottom on remote control.

FUNCTIONS

1- ON/OFF:

1st Press: The blower starts. LED light on.

2nd Press: The blower stops. LED light off.

2- BLOWER SPEED INCREASE +

Press & hold to increase the blower speed. Release pressure at the desired speed.

Note: The blower initially starts at 30% speed.

3- BLOWER SPEED DECREASE -

Press & hold to decrease the blower speed. Release pressure at the desired speed.

4- PULSATION MODES

1st Press: Wave - Speed will vary gradually from maximum to minimum. LED light on.

2nd Press: Pulse - Speed will go directly to minimum and then straight back to maximum.

LED light will flash.

3rd Press: Returns to maximum speed. LED light off. Press button #3 to decrease blower speed.

AUTOMATICALLY STOPS AFTER 20 MINUTES

STANDARD DRYING CYCLE WITH WATER DETECTORS

The system is equipped with two sensors on the oor of the bath near the drain. Every time water is introduced to

the bath and drained, either by showering, bathing or cleaning, the sensors will activate the drying cycle. The cycle

will start approximately 7 minutes after the bath is drained and run for 1-2 minutes. The drying cycle will activate

even when the air system has not been turned on. The blower LED blinks (on keypad only) during the drying cycle

countdown. This countdown cannot be cancelled. Any attempt to cancel this cycle only resets the countdown timer.

Please visit mtibaths.com/support/installation_operation/how-to-videos for detailed operation instructions.