DESIGNER COLLECTION D r o p - i n a n d U n d e r m o u n t S o a k i n g Tu b s O P E R AT I O N & C A R E M A N U A L Effective February 1, 2014
OPTIONAL EQUIPMENT OPERATING INSTRUCTIONS INLINE HEATER Depress the on/off button to turn the system on, press again to turn the system off. The system gently recirculates the bath water through the inline heater, with negligible disturbance to the water. The heatsoak system requires a dedicated 110 VAC, 20 AMP, GFCI protected outlet. Both the pump and inline heater must be plugged in for system to operate properly. RADIANCE To turn the system on, press the button on the touchpad.
STREAM BATH Prior to installation, this bath must be water tested in accordance with the procedures outlined on page 2. The tub will then be installed following the instructions starting on page 3. To operate the unit, fill the tub to approximately 2” above the highest vent. Activate the on/off control on the keypad. The flow, and force, of the stream of water may be adjusted by turning the vents.
