Installation Sheet

Care and Cleaning
Installation and Operational Manual
°
Designer Collection
°
Mineral Composite Tubs
mtibaths.com / 8
Care and Cleaning Instructions
The mineral composite surface of all MTI air baths and soaking baths is among the glossiest, highest quality
surfaces available. Its hard, non-porous surface prevents dirt from accumulating and resists stains better than
other materials. With normal use, your bath will retain its beauty with only a minimal amount of care. To maintain
the high gloss, elegant look of the mineral composite (MC) surface, follow these simple steps:
˚
Use common household, non-abrasive cleaners for most cleaning jobs (for example: a mild dishwashing
detergent such as Ivory Liquid). Follow manufacturer’s directions and precautions. Do not use unless the
product label specifically states that it is safe for acrylic or plastic. Rinse well and dry with a soft, clean cloth.
Be sure to check the product label. Some products, although not containing abrasives, WILL damage the
product over time. Never use any type of “scrubbing bubbles” or aerosol spray cleaners on your product
unless it specifically states that it is safe for use on acrylic or plastic. Never use abrasive cleansers. If any
product feels gritty when rubbed between your fingers, do not use on the product or controls as permanent
damage will occur.
˚
Do not allow your mineral composite surface to come into contact with nail polish, nail polish remover,
Wintergreen oil, dry cleaning solution, lacquer thinners, gasoline, pine oil, etc.
˚
Avoid using razor blades or other sharp objects that might scratch the surface. Small scratches can
typically be removed.
˚
Remove dust and dry dirt with a soft, damp cloth.
MTI strongly recommends a professional surface repair person for deep scratches or chips.