Installation Sheet
Installation Instructions
Installation and Operational Manual
°
Designer Collection
°
Mineral Composite Tubs
3 / mtibaths.com
ATTENTION: This tub must be tested for operation and leaks prior to enclosure of surrounding areas. Failure to
do so will void warranty. This tub was water tesated at the factory and found to be fully operational and leak-
free prior to shipping. Freight, handling and job site exposure may have deteriorated the tub’s condition. It is the
responsibility of the installer to thoroughly test the unit prior to installation. Tubs are intended for indoor use only.
Tubs are warranted for indoor installation in a climate controlled environment only.
See troubleshooting section of this manual, call for assistance at 800-783-8827 or email service@mtibaths.com.
Always protect the tub from construction damage by using a protective cover. Damage, including chips and
scratches, incurred at the jobsite is excluded from warranty, but may be repaired by qualified technician at the
owner’s expense. Do not stand in the tub or store materials in the tub during construction. Do not store tub in
temperatures below 32 degrees Farenheit. Proper waste and overflow installation is the responsibility of the
installer. MTI does not warrant leaks associated with improper waste and overflow installation.
˚
Place the tub on a flat surface such as the driveway.
˚
Seal the drain with tape.
˚
Fill tub to overflow and allow tub to stand for five minutes without the blower running.
NOTE: The overflow is a plumbing device designed to help prevent water from reaching a certain level in your
tub. Do not, under any circumstances, tape o or block the overflow in any way.
˚
Plug in the blower and any other components into a 110v GFCI outlet. Start the equipment and check for leaks
by examining the area underneath and surrounding the tub.
˚
Check that all optional equipment is functioning properly and that the features on the tub match exactly what
was ordered.
˚
If any leaks or operating problems are discovered, do not complete installation until problems are resolved.
MTI will not be responsible for leaks claimed after the tub is installed, nor any costs involved with removing or
reinstalling the tub or the costs of any surrounding materials or labor.
TEST PROCEDURES FOR AIR BATHS:
Installation Instructions