Installation Sheet

2
INSTALLATION AND OPERATION
GUIDELINES
Read all instructions before installing tub. Installer / product owner is responsible for complying with all
state and local codes. Warranty coverage will be void if unit is not tested and installed per the enclosed in-
structions. MTI strongly recommends using licensed professionals to install this product. Warning: Certain
cleaning products will permanently damage the acrylic surface. Read product label carefully before
using any cleaning product. Never use anything abrasive, aerosol sprays or any product that is
described as “scrubbing bubbles”.
BEFORE INSTALLING:
Inspect tub thoroughly.
A. Damage from shipping or delivery must be reported to carrier immediately. Do not install
damaged tub. MTI is not responsible for damage occurring in transit.
B. Factory defect must be reported to factory before tub is installed. Defects or damage claimed
after installation will be excluded from warranty.
C. Important - Measure tub on site carefully before framing or cutting any deck materials.
Specifications are subject to change without notice. MTI Baths is NOT responsible
for any preparatory labor or materials.
ATTENTION INSTALLER!
THIS TUB MUST BE TESTED FOR OPERATION AND LEAKS PRIOR TO ENCLOSURE OF SUR-
ROUNDING AREAS. FAILURE TO DO SO WILL VOID WARRANTY. THIS TUB WAS WATER TEST-
ED AT THE FACTORY AND FOUND TO BE FULLY OPERATIONAL AND LEAK-FREE PRIOR TO
SHIPPING. FREIGHT, HANDLING AND JOB SITE EXPOSURE MAY HAVE DETERIORATED THE
TUB’S CONDITION. IT IS THE RESPONSIBILITY OF THE INSTALLER TO THOROUGHLY TEST
THE UNIT PRIOR TO INSTALLATION. TUBS ARE INTENDED FOR INDOOR USE ONLY. TUBS ARE
WARRANTED FOR INDOOR INSTALLATION IN A CLIMATE CONTROLLED ENVIRONMENT ONLY.
TEST PROCEDURES
1. Place the tub on a flat surface such as the driveway.
2. Seal the drain with tape.
3. Fill tub to overflow and allow tub to stand for five minutes without the pump running. Examine
all fittings carefully for leaks. NOTE: The overflow is a plumbing device designed to prevent water
from reaching a certain level in your tub. DO NOT, under any circumstances, tape off or block the
overflow in any way. Any controls located above the normal water line are designed to be water-
resistant, not water-proof. The controls will not leak under normal usage, however, they are not
warranted against leaks when improperly used or subjected to conditions for which they were not
designed.
4. Plug in the inline heater and pump, Radiance or LED light control box into a 110v GFCI outlet.
Start the equipment and check all fittings for leaks and proper operation.
5. Check that all the features on the tub match exactly what was ordered.
6. If any leaks or operating problems are discovered, do not complete installation until problems
are resolved. MTI will not be responsible for leaks claimed after the tub is installed, nor any costs
involved with removing or reinstalling the tub or the costs of any surrounding materials or labor.
See troubleshooting section of this manual or call for assistance: 800-783-8827