Product Manual

CX FLEX™ 4A PRODUCT MANUAL

To silence an alarm, hold the user card over the RFID icon. To disarm after silencing an alarm, hold the user card over the

RFID icon again (2 + 4 beeps). Alarm events on any port will trigger an alarm, and the LEDs for the affected individual port

or ports will ash red/white along with the system (side) LEDs. Other armed ports LEDs remain white.

MANAGING ALARMS

Remove the cable.

Insert a corner of the RFID card into the slot and press

down until the cable detaches.

REMERCHANDISING

CABLE REMOVAL

Re-arm by holding user card over

RFID icon or system will auto-arm

after 1 minute.

Insert new cable until it clicks.From an armed state, place the

User Key over the RFID icon to

disarm the system. LED will be

ashing white. Then remove the

cable.

click

NOTE: If the issue causing the alarm is corrected while the system is

still alarming, holding the card over the RFID icon will immediately

re-arm the system (2 beeps).

If the issue causing the alarm is resolved after silencing the alarm,

the system will automatically re-arm after 1 minute without using the

RFID card or re-arm immediately by holding the User Key over the

RFID icon. (2 beeps).

2 + 4 beeps indicates card was successfully read (2 beeps), but can't

arm the system or all ports that are in use (4 beeps).