User manual

MPA82000 Power Amplifier
Specifications
500W Module 1000W Module
310W / 8Ω 670W / 8Ω
Output Power (measured @1kHz) RMS
580W / 4 Ω 1300W / 4Ω
Peak Power (measured @1kHz) 1 cycle 900W / 2Ω 2000W / 2Ω
Peak output current >45A >50A
Dynamic Range 117dBA 120dBA
THD+N < 0.1%, 0.1W – 500W, 4Ω < 0.09%, 0.1W – 1000W, 4Ω
Efficiency 93% @ 300W / 8Ω 93% @ 500W / 8Ω
Output impedance < 5mΩ @ 1kHz < 5mΩ @ 1kHz
Power Supply Rejection Ratio > 60dB > 60dB
Output DC-offset < 25mV < 40mV
Nominal Voltage Gain @ 1kHz +27dB +28dB
Frequency Response +/- 0.5dB 20Hz-20000Hz 20Hz-1000Hz
DF Damping factor ZL = 8, f = 100Hz 2000 2000
Minimum Load Impedance 2 Ω 2 Ω
Dimensions H x W x D 133mm (3U) x 483mm (19”) x 535mm
Weight 26kg
Power Requirements 200-250VAC (50-60Hz). 1A standby, 2A quiescent, 32A peak
Accessories
Hardware:
USB to RS485 adapter
COM Port (RS232) to RS485 adapter
Hardware dongle for changing presets
RS485 termination for long cable runs
Data cable for connecting amps
Software: Presets for MTI speaker range
Routine Maintenance
MTI MPA82000 Amplifiers are designed to give long and reliable operation and require very little
maintenance.
SAFETY NOTICE: Please note that power to the amplifier modules is ALWAYS on when the
amplifier is connected to the mains supply. Therefore when carrying out any maintenance the
amplifier must be disconnected from the mains supply.
As with all power amplifiers it is important to ensure that the cooling vents are not blocked and that
adequate airflow is maintained through the amplifier. Periodically check that no obstructions exist
around any of the amplifier ventilation paths. This is particularly important when the amplifier is in a
rack or case.
Page 11