User's Manual

BDA Installation and Operating Guide
Version 1.0 14
2.2 Cable Connection to BDA
2.2.1 Connection of RF cable and electrical power cable to BDA
Service antenna port is to be connected to the “SVC ANT” port of BDA with RF cable.
“LINK ANT” port of BDA also connected to link antenna with 50ohm feeder. Refer to the
below figure for the connection port at the unit.
AC Power (100V ± 20%) is supplied to the unit with the AC Power cord. Plug the AC power
cord into the connector. Before apply the power source, Connect grounding cable between
CHASSIS port locating left side of the BDA and Ground bar. Refer to the following figure
for the connection port on the BDA.
Figure 11 Cable Connection of the BDA
Figure 12 Interfacing port of BDA bottom side