User Manual

Table Of Contents

Wireless Network Planning

Procedure 1 (Location)

1. Select and identify enough location candidates to determine freely as

the install point regardless of some design change to some extent.

2. The most crucial parameter is the range at which APU and CSU or

other Wi-Fi Client are required to operate. The range can be

determined by a conventional formula which consider a various kinds

of environmental and radio equipments.

3. Another consideration in installing APU and CSU is the network

connection like a CATV Coaxial Cable and CAT5 Ethernet Cable.

Even though some location is the best location in terms of RF

performance, the actual installed location is restricted by a limitation

of cable reach.

Procedure 2 (Radio Link Path)

1. Choose the proper antenna type with a site survey result.

2. For best performance, mount the APU and CSU in a location where

there is LOS(Line Of Sight) to each antenna.

3. Perform the field survey to summarize every obstacle like tree and

earth bulge in consideration of OLOS(Optical LOS).

4. With the site survey result, adjust the tilt and angle of antenna so that

there is maximum clearance within the FRESNEL ZONE of the

direct path.

Note: The best means of achieving FRESNEL ZONE clearance is to

raise the height of APU or CSU mounting point as high as possible

5. In order to get the more exact information on RF radio link path,

Calculate the Link Budget for Radio Link between APU and CSU

which is referred in the end of this section.

Note: The link budget is a rough calculation of all known elements of the

link to determine whether the signal will have the proper strength to the