User Manual

43
Figure 3-13
Combining Back Nut with Main Nut
12. In order to prevent damage to the connector on APU enclosure, cut
the pin of Body connector to the length of 0.59 inch(15mm) with a
cutting tool
13. Install the Body connector to the enclosure and tighten strongly
Figure 3-14
Adjusting the length of the center conductor
MAKE SURE THAT THE PIN LENGTH OF BODY CONNECTOR DOES NOT
EXCEEDS 15mm(0.59055 inch) TO PREVENT DAMAGE TO THE JOINT
PORTION OF THE HFC FILTER IN THE ENCLOSURE
14. Bring the main nut and cable to the body connector, Hand-tighten
many nut to body continually keeping pressure on cable towards the
body so that the center conductor will be properly seized.
15. Using two wrenches, one wrench to hold the BODY from rotation,
continue tightening the main nut to the body until a firm stop is
reached.
16. Tighten the back nut by hand, then using two wrenches, one on the
main nut, complete installation by tightening the back nut firmly to
secure the cable (approximately 35 lbs, ft)
17. Secure the center conductor into equipment enclosure with the
seizing screw
WLAN Cable Access Point 6220 NTPM99CA Rel 1.0 Issue 1 Aug 2004