User Manual

47
Figure 3-21
Connecting the coaxial cable to the connector port
MAKE SURE THAT THE POWER SOURCE IS TURNED OFF PRIOR TO CONNECTING
COAXIAL CABLE (75 ohm) TO PROTECT AN INSTALLER FROM ELECTRICAL SHOCK
8. Slide the heat shrink tubing over the connector against the APU.
9. Shrink the tubing with a painting motion not concentrating on any
one area using a propane/Mapp torch with a broad “soft” frame.
Figure 3-22
Shrink the tubing for a Water Proof
WLAN Cable Access Point 6220 NTPM99CA Rel 1.0 Issue 1 Aug 2004