User Manual

56
4. Secure the cable in the EMI cap by tightening it with a cable tie.
Over-wrap the connectors with black self amalgamating tape or shrink
the tubing with sliding over the cable to ensure a waterproof sealing.
This is the most crucial step of the installation. If this procedure is not
completed, a long-term and complex problems could occur.
5. Tighten the EMI cap securely with the special tool including the
product package.
WHEN INSTALLING THE UNIT, CHOOSE A LOCATION THAT PROVIDES A
MINIMUM SEPARATION OF 20 cm FROM ALL PERSONS DURING NORMAL
OPERATION.
Figure 3-30
Over-wrapping the EMI Cap and Shielded Cable with a Tape or shrink tube
6. Connect the ground wire to the ground point at the lower right end of
CSU back panel.
Figure 3-31
Connecting the ground wire to the ground point
7. Connect the other end of the data cable to the POE Injector indoor.
8. Plug the power cord of the POE Injector into an electrical outlet
WLAN Cable Access Point 6220 NTPM99CA Rel 1.0 Issue 1 Oct. 2004