m-trim.
- Clamps Framing Square Finishing Nails, Nail Set and Hammer or Brad Nailer Hearing Protection Level Miter Box, Miter Saw or Compound Miter Saw Pen and Paper Protractor Square Safety Glasses Tape Measure Utility knife Wood Filler and Glue m-trim.
Install moldings m-trim.com 1 Take measures of walls, windows and openings in the room and round up to the nearest foot. It is recommended to add 15% for waste. 2 Must moldings are installed with a 90 degree angle joint. Cut 2 pieces of molding with a 45 degree angle each piece and together they make 90-degree angle. Use WPB Cement to glue the ends of the boards. On both sides place fasteners 2” from the end. First install the longest pieces.
Install moldings m-trim.com 3 How Do I Splice a Molding? To span longer lengths, you may have to splice moldings. Mitre the joining ends at 45° angles from front to back. One member will overlap the other in a scarf joint, creating a vertical face seam in the finished installation. It is advisable to join molding pieces over wall stud for additional strength. 4 Always wear eye, ear and respiratory protection when doing any home improvement project. Cut and mill in a well-ventilated area.
m-trim.com | 800.600.
