Instruction Manual

709 Alignment System
Options
66
FieldPoint Data Acquisition
The fields in this section of the tab show the read only parameters relating to the
FieldPoint hardware.
Global Settings
Load Analog Input
Signal
The entries in this area define the parameters relating to the load signals used by
the 709 alignment software.
Add - Click this button to add a load input signal. This could be a load signal
from a second load cell for a given load unit, a load signal from a different
calibrated load range, or a load signal from another load frame station.
Remove - Deletes the load signal shown in the pulldown menu field.
Gain - This field defines the scaling used by the 709 Alignment software when
displaying or graphing the load analog input signal.
check box - The Enable in Align and Validate tabs check box, when checked,
enables the load analog input signal to be displayed in the indicated tabs; AI in
the Align tab Load bar graph, Load (AI) in the Validate tab.
Validate Chart X-Axis These radio buttons determine whether the analog input (AI) or the strain gauges
(SG) will be used for the validate chart. The choice here also determines the
starting selection for the x-axis on the validate chart.
Validate tab x-axis selections
Options tab
Analog input selections
Strain Gauge selections