Technical data

Valve Gear 6–13

6.4.2 Cylinder-head cover – Removal and installation

Preconditions

• Engine is stopped and starting disabled.

Special tools

Designation / Use Part No. Qty.

Torque wrench

Spare parts

Designation / Use Part No. Qty.

Gasket

Preparatory steps

1. On cylinder-head covers with crankcase breather: Loosen clamps.

2. Slide rubber sleeves onto the pipe.

Cylinder-head cover – Removal and installation

1. Remove screws.

2. Remove cylinder-head cover with gasket from

cylinder head.

3. Clean mating faces.

4. Check condition of gasket in cylinder-head cover.

5. Replace damaged gasket(s).

6. Pl

ace cylinder-head covers onto crankcase and

tighten screws to 20 N m.

Final steps

1. Slide rubber sleeves onto the relevant pipe connection.

2. Tighten all clamps.