Technical data

Injection Pump / H P Pump 6–17
Final steps
1. Remove barring tool (→ Page 6 – 01).
2. Clean mating faces on cylinder head and
charge-air manifold.
3. Check gaskets for damage and replace them, if
required.
4. Set gasket onto cylinder head.
5. Install charge-air manifold.
6. Install engine control system (→ Page 6 – 63).
7. Open fuel supply line before fuel filter.
8
.
V
ent fuel system (→ Page 6 – 23).
M015560/00E 03-05 ©MTU