Operating instructions

2 Engine

Barring engine with starting system

1. Disengage the bayonet ring-nut (4) of connector

X4 with connector pliers (2) and withdraw

connector (3) from ECU.

2. Bar engine in unloaded condition: Press START

button.

3. Let the crankshaft rotate until oil pressure is

indicated.

4. Engine start is automatically interrupted when

specified starting period is expired. If necessary,

re-start the engine after approx. 20 seconds.

5. Plug connector X4 (3) and use connector pliers

(2) to secure the bayonet ring (4) by turning it

clockwise until it latches into place.

6.1.3 Engine test run

DANGER

Unguarded rotating and moving engine components.

Risk of serious injury  danger to life!

 Before barring or starting the engine, ensure that nobody is in the danger zone.

WARNING

Engine noise above 85 dB (A).

Risk of damage to hearing!

 Wear ear protectors.

Engine test run

1. Start engine (

Page 3  2).

2. Perform test run at not below 1/3 load and at least until steady-state temperature is reached.

3. Carry out operational checks (

Page 3  4).

4. Stop engine (

Page 3  5).