Operating instructions

Fuel Injector   19

11. Use slotted screwdriver to check thrust ring at

both line ends for secure seating.

12. Tighten loose thrust ring to 10 Nm.

13. Fit hold-down clamp (1) in correct position and

install screw (2) by hand.

14. Tighten screw (2) with torque wrench, preliminary

tightening torque: 5 Nm to 10 Nm.

15. Coat new O-rings (4) and (6) on with petroleum

jelly and fit on HP fuel line (5).

16. Install HP line (5) and tighten preliminarily,

tightening torque: 5 Nm to 10 Nm.

17. Tighten screw (2) to 100 + 10 Nm.

18. Tighten HP fuel line to 120 Nm + 12 Nm.

19. Fit cable terminals below the screws on injector

and tighten to 1 Nm.