Operating instructions

Oil Filtration / Cooling   37

6.14.2 Centrifugal oil filter  cleaning and filter-sleeve replacement

Preconditions

 Engine is stopped and starting disabled.

Special tools

Designation / Use Part No. Qty.

Strap wrench

Material

Designation / Use Part No. Qty.

Cleaner Hakutex 60

FLS

Spare parts

Designation / Use Part No. Qty.

Filter sleeve

SPC

Sealing ring SPC

WARNING

Hot engine oil.

Engine oil can contain combustion residues which are harmful to health.

Risk of injury and scalding!

 Wear protective clothing, gloves, and goggles / safety mask.

 Avoid contact with skin.

 Do not inhale oil vapor.

WARNING

Compressed air.

Risk of injury!

 Do not direct compressed-air jet at persons.

 Wear protective goggles / safety mask and ear protectors.

Centrifugal oil filter  cleaning and filter-sleeve

replacement

1. Remove clamp (3).

2. Release Tommy nut (1) and take off cover (2).

3. Carefully remove rotor (5) from housing.

4. Remove knurled nut (7) on rotor cap, holding the

rotor with strap wrench.

5. Take off rotor cap (8).

6. Remove filter sleeve (9) and stiffener plate (10).

7. Measure thickness of oil residues on filter sleeve.

8. If maximum layer thickness of oil residues

exceeds 30 mm, shorten maintenance interval.

9. Remove sealing ring (11) and standpipe (12).

10. Wash cover (2), rotor cap (8), stiffener plate (10),

standpipe (12) and lower rotor section (13) with

cleaner and blow out with compressed air.

11. Fit new sealing ring (11) on rotor lower section

(13).