Operating instructions

Abbrevia‐
tion
Meaning Explanation
IMO International Maritime Organization
ISO International Organization for Stand‐
ardization
International umbrella organization of all standards
institutes
KGS Kraftgegenseite Engine free end in accordance with DIN ISO 1204
KS Kraftseite Engine driving end in accordance with DIN ISO
1204
LCD Liquid Crystal Display, Liquid Crystal
Device
LCU Local Control Unit LOP subassembly
LED Light Emitting Diode
LMU Local Monitoring Unit LOP subassembly
LO Low Alarm: Measured value below 1st minimum limit
value
LOLO Low Low Alarm: Measured value below 2nd minimum limit
value
LOP Local Operating Panel Control console, control panel
LOS Local Operating Station
MCS Monitoring and Control System
MG Message
MPU Microprocessor Unit, Microprocessing
Unit
OT Oberer Totpunkt Top dead center (TDC)
P-xyz Pressure-xyz Pressure measuring point xyz
PAN Panel Control panel
PAU Power Automation Unit Module for monitoring, control and plant-related
system integration of peripheral components
PCU Propeller Control Unit
PIM Peripheral Interface Module
PLD Pumpe Leitung Düse Pump-line-nozzle (injection system)
POM Power Output Module Module to control starter and battery-charging gen‐
erator
RCS Remote Control System
RL Redundancy Lost Alarm: Redundant CAN bus failure
SAE Society of Automotive Engineers US standardization organization
SD Sensor Defect Alarm: Defective sensor
SDAF Shut Down Air Flaps Emergency-air shutoff flap(s)
SS Safety System Safety system alarm
SSK Schnellschlussklappe(n) Emergency-air shutoff flap(s)
T-xyz Temperature-xyz Temperature measuring point xyz
TD Transmitter Deviation Alarm: Deviation in transmitter values
UT Unterer Totpunkt Bottom dead center (BDC)
VS Voith Schneider Voith-Schneider drive
118 | Appendix A | MS150095/01E 2012-08
TIM-ID: 0000002045 - 013