Operating instructions

Cleaning centrifugal oil filter
and replacing filter sleeve
1. Remove clamp (14).
2. Undo cover screw (2) and take off cov-
er (1).
3. Carefully lift rotor (11), allow oil to drain
and remove from housing.
4. Holding the rotor (11) firmly, release rotor
cover nut (3).
5. Take off rotor cover (4).
6. Remove filter sleeve (6).
7. Measure thickness of oil residues on filter
sleeve (6).
Result: If the oil residues exceed the maximum lay-
er thickness of 45 mm, shorten the service
interval.
8. Dismantle rotor tube (7), conical disk (8)
and rotor base (10).
9. Wash rotor cover (4), rotor tube (7), conical
disk (8) and rotor base (10) with cold
cleaner.
10. Blow out with compressed air.
11. Check sealing ring (9), fit new one if neces-
sary.
12. Assemble rotor tube (7), conical disk (8)
and rotor base (10) together with sealing
ring (9).
13. Insert new filter sleeve (6) in rotor tube (7)
with the smooth paper surface facing the
wall.
14. Check sealing ring (5), fit new one if neces-
sary.
15. Mount rotor cover (4) and sealing ring (5).
16. Tighten rotor cover nut (3) to the specified torque using torque wrench.
Name Size Type Lubricant Value/Standard
Nut Tightening torque 35 Nm to 45 Nm
17. Place rotor (11) in housing (12) and check for ease of movement.
18. Check sealing ring (13), fit new one if necessary.
19. Fit sealing ring (13) on housing (12).
20. Fit cover (1).
21. Tighten cover screw (2) by hand.
22. Fit clamp (14) and tighten to the specified torque using torque wrench.
Name Size Type Lubricant Value/Standard
Clamp Tightening torque 8 Nm to 10 Nm
23. Tighten cover screw (2) to the specified torque using torque wrench.
Name Size Type Lubricant Value/Standard
Screw Tightening torque 5 Nm to 7 Nm
102 | Task Description | M015675/06E 2013-04
TIM-ID: 0000000934 - 012