User manual

places the switch in the QUIET (middle) position. RF
transmissions from systems that are emitters and that are
active are reduced. In particular, the main APG-68 radar
set does not transmit in this mode. This command only
operates if realistic avionics are selected.
SimRFSilent Refers to the RF switch on the MISC panel. This command
places the switch in the SILENT (down) position. All RF
transmissions suppressed including APG-68, CARA and
TFR transmitters. This command only operates if realistic
avionics are selected.
SimDropProgrammed SP3 command. Should be used to map to the CMS hat
switch on the control switch. Probably matches the “up“
(TM syntax: H4U) position. In Realistic Avionics mode, this
command runs the selected countermeasures program.
SimPinkySwitch SP2 command.
SimGndJettEnable SP2 command.
SimGndJettOn Refers to the GND JETT switch on the landing gear panel.
This command places the switch in the ENABLE position
which allows stores to be jettisoned while on the ground.
This commands also allows the ECM pod to emit (this is
normally disabled on the ground). This command only
operates if realistic avionics are selected.
SimGndJettOff Refers to the GND JETT switch on the landing gear panel.
This command places the switch in theOFF position which
prevents stores from being jettisoned while on the ground.
This commands also prevents the ECM pod from emitting.
This command only operates if realistic avionics are
selected.
SimExtlPower SP2 command.
SimExtlMasterNorm Refers to the MASTER switch on the EXT LIGHTING
panel. This command places the switch in the NORM
position and enables the operation of the external lights.
This command only operates if realistic avionics are
selected.
SimExtlMasterOff Refers to the MASTER switch on the EXT LIGHTING
panel. This command places the switch in the OFF position
and disables the operation of the external lights. This
command only operates if realistic avionics are selected.
128