User manual

Fixed the ACM slewable scan search altitude display numbers to show negative numbers and
red when negative. Also fixed the spacing between them so they're not scrunched up together.
Fixed the DLZ in the MFD. It was placed too far low and the Time to Active/Time to Impact
numbers were way too low and to the left.
The lower/upper numbers of the cursor altitude coverage show negative numbers and turns them
to red when they are negative.
In Freeze mode, a circle with a line sticking out is now displayed, instead of an airplane cross.
ILS Command Steering defaults to being on.
Fixed the HSD bugged target symbol (the ]- symbol).
The pre-launch/post-launch missile time prefixes were wrong for the HUD, regarding time-until-
active and time-until-impact. Changed the equations to match those of the MFD, which was
correct. Small, but important realism bug fixed.
Changed the HTS cursor to be twice as fast.
Removed an unnecessary scaling factor that dealt with drag. Previously stores drag was
calculated by DragIndex times ( 18238 divided by aircraft empty weight). Now the stores drag is
just DragIndex.
The AOA Indexer next to the HUD is now operational regardless of the gear being up or down.
This is per the F-16 technical order.
Adjusted blackout/greyout numbers per USAF guide on GLOC and pilot’s input. This should
better simulate a good AGSM and Combat Edge equipment
When Bullseye mode is off, (LISTÆ0, 8 , then 0 to toggle on and off), the bearing and range from
the current INS steerpoint to the radar cursors is drawn in the FCR Bscope and the HSD.
The ACMI recording message, "RECORDING: ++++" that is show at the top of the screen can
now be turned off by checking ACMI Record Msg Off (set g_bACMIRecordMsgOff 1) in the
Config Editor.
Falconbms.cfg variable: set g_fHSDSymbolSize 0.025
The bullseye circle on the HSD and on the radar was too large. Set the value to “1” if you would
like a smaller bull’s-eye circle (NOT recommended for resolutions below 1280x1024.
Falconbms.cfg variable: set g_bSmallerBullseye 0
30